![]() ![]() After cutting the boards, sand them thoroughly using medium to high-grit sandpaper, which will make it easier to paint or stain the boards after your desktop is built. ![]() ![]() To ensure that your desk has a nice sturdy top, choose boards that are at least 2 in (5.1 cm) thick. For a 4 ft (1.2 m) by 2 ft (.6 m) desk, you’d just need to cut a pair of 8 ft (2.4 m) by 6 in (15 cm) boards in half lengthwise. Once you’ve decided on your dimensions, measure and cut some planks to the right size to make the desktop. For instance, you might decide to make your desk 4 ft (1.2 m) long and 2 ft (.61 m) wide by 30 in (76 cm) high. To get started, measure the area where you’d like your desk to be so you know how big to make it. Paint or stain your table legs to match your desktop, or leave them unfinished to provide some visual contrast.īuilding a desk from scratch is a fun and affordable alternative to buying a premade desk.Similarly, you’ll need to subtract 1.5 inches (3.8 cm) from your initial table leg measurements to reflect the thickness of the desktop-you want your desk to sit 28 inches (71 cm) off of the ground, for example, each of your legs will need to be 26.5 inches (67 cm) long.This means that if your desktop is 24 inches (61 cm) wide, each of your support pieces will need to be 21 inches (53 cm) to allow enough room for a leg on either side. Note that 2x4 boards are actually only 1.5 inches (3.8 cm) thick, not a full 2 inches (5.1 cm).Their length should correspond to the desired height of your desk, minus the width of the boards making up the desktop. Once you’ve done this, cut your remaining wood into 4 identical legs. These pieces will serve as supports to brace the desk from beneath. Start by sawing a 2x4 board into 2 pieces that are the same width as your desktop, minus the width of the two legs that will go on either side. Cut your own custom desk legs using 2x4 boards. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |